Mini Regulator

Smaller Version of the Old Regulator, still comes with two magnets to mount onto your wig, hat or headband, also comes with the same magnetic mounting clip + 2 extra loose magnets for your own attaching process.
However it comes with a new light-chip that is a bit weaker but is operated by a magnetic switch. Get a magnetic field changing close to it and it will power on/ go to the next setting and yes the magnetic clipper will affect it so attaching it to the mounting clipper will if done right power on the device.

Dimensions:
5.5cm diameter
2 cm high

Pics are showing lit up version one inside the other in half-shade on a very sunny day.

IMPORTANT NOTE: The onboard-chip is hard-coded to auto-shut off after 5 minutes and can only do animations aka moving lights (circular) in different speeds. there is no way of changing that.

The LED board only comes in a single color and is NOT RGB but the whole regulator can be changed to be a red light one on request at the moment you're ordering. once it's shipped no way to change it since even the diffuser inside has to be swapped while in production so it's a hard-set color once it's done. (This is to make the Regulator show up in the chosen color even if it's turned off)

For power the board uses an CR1625 buttoncell battery, to switch it you need open the case, twist the board by 90° (it's pretty snug in it's clasp) until the flat parts are in the clamps so it can come loose. Then you can take a screwdriver or toothpick or anything really that is thin enough to push out the power cell from underneath the board. Then just reverse the process with a new power cell and assemble everything and done!

Will take somewhere between 2-6 weeks to produce depending on material deliveries as they are made to order in small batches.